Case Loader Backhoe 580 Super L

Replace Hydraulic Filter (See Note 4)

1. Lower the loader bucket to the ground and apply the parking brake.

3. Use a filter wrench and remove the old filter from the machine.

4. Lubricate the gasket on the new filter with clean oil.

5. Install the new filter and turn clockwise until the gasket contacts the head of the filter assembly. Continue to tighten the filter for 1/3 turn.

6. Start the engine and check for leaks at the hydraulic filter.

Change Hydraulic Fluid (See Note 4)

Change the hydraulic fluid every 1000 hours of operation.

Clean Spark Arresting Muffler (If Equipped)

WARNING: The spark arrester is not intended to be used in closed areas where there is dust or vapor that can cause an explosion.

Engine stopped and loader bucket on the ground

Plug removed from the side of the muffler

Check Air Conditioning Drive Belt Condition (If Equipped)

WARNING: Rotating fan and belts: Contact will cause injury. Keep clear.

Check the tension of a new drive belt after the first 10 hours of operation. Then, check the tension of the drive belt every 250 hours of operation.

Check the belt with a belt tension gauge, and adjust the belt to 20 to 25 kg (45 to 55 pounds).

1. Lower the loader bucket to the ground and stop the engine.

3. Loosen the pivot bolt of the air conditioner compressor.

Check for leaks under the machine.

Check the machine for broken, missing, or loose parts.

Clean any debris from the machine. Make sure the radiator area is clean.

Clean or replace any safety or instructional decals that cannot be read.

Clean the steps, hand rails, and operators compartment.

NOTE: If this is a new machine, or a machine with a rebuilt engine, see RunIn Period on page 65 for additional information.

Sign off on the daily walk-around inspection

WARNING: Hot coolant can spray out if radiator cap is removed. To remove radiator cap: Let system cool, turn to first notch, then wait until all pressure is released. Scalding can result from fast removal of radiator cap.

Check and service engine cooling system according to maintenance instructions.

Drain, flush, and replace the engine coolant every 2000 hours of operation or every two years, whichever occurs first.

Clean the system and replace the coolant if the coolant becomes dirty or has the color of rust.

DO NOT remove the radiator cap if the coolant is hot. Allow the system to cool, then:

Put a container under the drain valve that will hold 19 litres (5 U.S. gallon).

Open the radiator drain valve and remove the radiator cap.

After all coolant is removed, close the drain valve.

Add cleaning solution to the cooling system and fill the cooling system with clean water. Follow the directions included with the cleaning solution.