Case Compact Tractor 2510

Warning: This inspection requires trained personnel with PPE!

Enter the machine's hour meter reading

Are the breaker contact points in good condition?

If the breaker contact points are not in good condition, report the issues to the maintenance team and stop the procedure

Choose the color of the contact points

If the color of the contact points is black or blue, report the issues to the maintenance team and stop the procedure

Select the cause of the contact point surfaces being blue

Are the contact surfaces showing normal wear patterns?

Sign off on the 100 Hourly Crawler Excavator Inspection

Battery terminals and cables in good condition

Describe the condition of the battery tray, holdown terminals and cable ends

Is the battery case cracked or leaking?

Is the top sealing compound leaking?

Vent holes in the filler caps are open

Amount of water added to the battery

Is the case leaking or regulator overcharging?

Warning: This procedure should be performed by trained personnel only

Volt meter reading after 15 seconds

Is the volt meter reading less than 9.5 volts?

Sign off on the battery bench load test

NOTE: On Spark Ignition engines remove the center coil wire to prevent engine from starting

Connect a volt meter (12 volt) between the positive and negative terminals of the battery

Crank the engine for 15 seconds and record voltage

Connect voltmeter (12 volt) between the starter generator 'A' terminal and ground on starter generator frame

Crank the engine and record voltage

If voltage is not the same or varies more than .5 volt, check the battery cables, clean and tighten connections

Sign off on the battery cranking voltage test

Ensure the drive belt is adjusted properly.

Disconnect all cables and wires to generator.

Connect ammeter and variable resistance in series between the 'A' terminal and generator frame.

Connect voltmeter from the 'A' terminal to the frame.

Install jumper lead from the 'F' terminal to the frame, Figure F-9.

Drive the unit at specified RPM.

Adjust to specified voltage by varying the resistance.

Is the ammeter reading lower than specified amperage?

If amperage output is too high, disconnect the jumper lead from the field 'F' terminal.