Bunn Digital Server SERVER DSG2

Warning: Do not submerge the server. Failure to follow the recommended cleaning procedures can cause corrosion to the stainless steel surface and damage the vacuum seal. USE OF ANY CHLORINATED PRODUCT VOIDS THE FACTORY WARRANTY

Empty server completely by opening faucet. Remove lid, fill server with approved multipurpose cleaning solution and thoroughly clean inside of server. Drain cleaning solution

Rinse server thoroughly using fresh water rinse

Remove faucet handle/stem assembly by unscrewing the faucet bonnet just beneath the faucet handle

Using approved multi-purpose cleaning solution, wash and rinse faucet spout & faucet tube, using clean and sanitized cleaning brush supplied by manufacturer

Using approved multi-purpose cleaning solution, wash. rinse, sanitize and air dry fill tube in lid assembly using cleaning brush supplied by manufacturer

Note: Never submerge the Digital ThermoFresh® Server Display or sensor assembly in water

Disassemble the faucet/stem assembly. Thoroughly wash all faucet parts, lid, and silicone tube in a mild detergent and water solution. Rinse the parts in hot water. Allow the parts to soak in sanitizer solution for five (5) minutes, then air dry completely

Remove drip tray and drip tray cover. Thoroughly wash in approved multi-purpose cleaning solution. Rinse parts in hot water

Warning: Only trained personnel should perform this procedure

Sensor assembly removed from the server

Two thumb screws removed and display assembly slid from the server

Two screws and cover on bottom of the display removed

Used batteries replaced with 4 AAA alkaline batteries

Display assembly replaced and secured with two thumb screws

Sign off on the server battery replacement