Bunn Brewer Titan Dual

Warning: Do NOT clean this equipment with a water jet device

Clean all surfaces on Bunn-O-Matic equipment with a damp cloth rinsed in any mild, nonabrasive, liquid detergent

Check and clean each sprayhead. The sprayhead holes must always remain open

NOTE: Any buildup on the sprayhead may restrict water flow, and impact your coffee brewing. For consistently great coffee, clean sprayheads weekly. Upon visual inspection it may appear that light passes through all holes in the sprayhead plate, but a thin film of residue can pass light and still impede water flow

Remove sprayhead from brewer. Disassemble by removing the seal

Use the pointed end of sprayhead cleaning tool to remove any mineral deposits from the sprayhead holes

Insert the long end of sprayhead cleaning tool into the sprayhead fitting, and rotate several times to remove any mineral deposits from the fitting

Insert the short end of sprayhead cleaning tool into the bypass fittings, and rotate several times to remove any mineral deposits from the fitting

Reassemble sprayhead and reattach. Sprayhead only needs to be hand tightened

Remove screws that secure the front access panel. Remove the panel

Unfasten the hose clamp at the end of the drain hose. Remove the plug

Place the end of the drain hose in a drain or a container that has a minimum capacity of 16.0 gallons (60.5 liters)

Release the white clamp to drain water from the tank

When tank is empty, close the white clamp, replace the plug, and tighten the clamp at the end of the drain hose

Replace the front panel and tighten screws

Sign off on the brewer tank maintenance