Bunn Brewer Server PN: 44050.0200

Warning: Ensure the server is turned off before starting the procedure

Remove the lid assembly from the server

Remove the two screws and then the cover on bottom of the lid

Number of used batteries removed

Number of new AAA alkaline batteries inserted

Sign off on the battery replacement

NOTE: Bunn-O-Matic recommends the three step method for cleaning and sanitizing the server. The 3 step method consists of hot soapy water using an mild, non-citrus detergent, a fresh water rinse and an aqueous sanitizing solution using a non-chlorine sanitizer. Do not submerge the server. Failure to follow the recommended cleaning procedures can cause corrosion to the stainless steel surface and damage the vacuum seal. USE OF ANY CHLORINATED PRODUCT VOIDS THE FACTORY WARRANTY

Empty server completely by opening faucet. Remove lid, fill server with approved multi-purpose cleaning solution and thoroughly clean inside of server. Drain cleaning solution

Rinse server thoroughly using fresh water rinse

Remove faucet handle/stem assembly by unscrewing the faucet bonnet just beneath the faucet handle

For Models with Mechanical Sight Gauge: Lift sight gauge slide and pull sight gauge tube from shroud

Using approved multi-purpose cleaning solution, wash and rinse faucet spout & faucet tube, using clean and sanitized cleaning brush supplied by manufacturer

Using approved multi-purpose cleaning solution, wash. rinse, sanitize and air dry fill tube in lid assembly using cleaning brush supplied by manufacturer

For Models with Mechanical Sight Gauge: Use cleaning brush supplied by manufacturer to thoroughly clean sight gauge tube

Disassemble the faucet/stem assembly. Thoroughly wash all faucet parts and lid in a mild detergent and water solution. Rinse the parts in hot water. Allow the parts to soak in sanitizer solution for five (5) minutes, then air dry completely

Remove the lid assembly from the server

Wipe the surface of the display unit, and area under the lid assembly with a clean damp cloth

Wash the entire outside surface of the lid assembly with a mild detergent and water solution and rinse with hot water. DO NOT SUBMERSE

NOTE: Thoroughly cleaning the lid assembly will prevent inaccurate level readings

Replace the display unit and lid assembly

Sign off on the cleaning procedure