Whitehall Manufacturing Whirlpool WHP-10-MU

Drain the tub following the draining instructions above.

For tubs greater than 75.7 L (20 US gallons), prepare the turbine

Fill the bucket or tub with water so the bottom of the turbine is at least 15.2 cm (6 inches) below the surface of the water.

Add a disinfectant solution to the water per manufacturer’s instructions.

Ensure the pressure control valve is in the open position.

Turn on the turbine for 5 seconds and turn it off.

Drain the tub following the draining instructions above.

Verify that the turbine is off.

Remove any loose objects or debris from the Whirlpool tub.

Select the cleaning materials used for disinfecting

Disinfect the tub using the selected materials.

Select the cleaning materials used for cleaning

Clean the tub using the selected materials.

Place the stem tip of a calibrated thermometer next to the tip of the Whirlpool thermometer

Check if the Whirlpool thermometer reading matches the calibrated thermometer

Adjust the Whirlpool thermometer

Turn off the turbine power switch (13) to stop water circulation.

Draining without separate drain pump

Connect hose to drain valve (15) and open the drain valve.

Rotate pressure control valve (11) counterclockwise.

Lower the pump (12) to the bottom of the tub.

Ensure cleaning materials are ready

Use a sponge or soft-bristle brush to clean the whirlpool surfaces

Use a soft cloth to wipe down the surfaces

Avoid using abrasive compounds or metal brushes

Ensure no steel wool comes in contact with stainless steel surfaces

Avoid cleaning products with strong acids or halogens (chlorine, fluorine, bromine, iodine)