Whirlpool Automatic No Frost Refrigerator WRT18YAWT

Disconnect refrigerator from power supply

Remove the screws of cover using a Phillips screwdriver

Reach behind the panel to remove bulb

Replace with a 40 watts appliance bulb

Disconnect refrigerator from power supply

Use a hand tool to release the lock in the middle of the light cover

Hold the cover by both sides and push to center to release from evaporator cover

Replace with a 15 watts T25 bulb, base E14

Ensure the valve has been securely placed again

Verify the valve is in contact with the tab placed in the water storage bin

Check that the isolating ring is securely placed in the water storage bin

Screw the valve to the water storage bin by turning clockwise

Replace the strap of the lid cap inside the lid and put the lid again over the bin

Replace the water storage bin holding with both hands by its sides

Lift up the front of the bin to align side guides with tabs in the inner door, then push firmly down until it has snapped completely

Disconnect the refrigerator to prevent electrical shock hazard

Prepare cleaning solution with a tablespoon of baking soda mixed in a liter of water

Clean the refrigerator interior with a soft cloth and mild detergent

Ensure no fibers or sharp objects are used during cleaning

Locate the condenser coils at the back of the refrigerator

Use a soft cloth or sponge to eliminate accumulated dust from the condenser coils