Travaini Vacuum pump TR0600V-1A

Access the frame reservoir (ITEM 1B)

Check the oil level using the visible indicators or access ports

If oil is low, top it up using appropriate make-up oil for the system

Any leaks observed around the reservoir, filter, and piping?

Sign off on the oil level check

Shut down and cool the pump completely. Disconnect power and isolate the unit.

Upload a photo of the isolated unit.

Refer to the 'Disassembly and Assembly Instructions' for your pump model (see manual reference).

Remove old bearings. Clean bearing housings thoroughly.

Upload a photo of the cleaned bearing housings.

Install new bearings of correct type

Apply correct grease type and amount

Test run pump and check for abnormal noise, heat, or vibration.

Sign off on the bearing replacement.

Lubrication Interval: Every 2000–2500 working hours or once per year, whichever comes first.

Sign off on the bearings lubrication

Ensure the pump is fully stopped, isolated, and depressurized

Disconnect the power supply and apply lockout/tagout procedures

Remove safety guards to access the pump and motor coupling

Clean the coupling area for accurate measurement

Measure alignment using a dial indicator, laser alignment tool, or straightedge and feeler gauge

Check for both angular and parallel misalignment

If misaligned, adjust the motor position using shims or sliding base

Tighten all motor and base mounting bolts securely

Recheck alignment after tightening to confirm accuracy

Note: In the event the pump remains out of service for more than 2 months it is recommended to replace the packing rings, prior to start-up.

1. ⚠️ Ensure the pump is not running before performing any adjustment or replacement.

2. Wear appropriate PPE to protect from hot or hazardous fluids.

3. Follow lockout/tagout and safety procedures per Chapter 2 of the manual.

1. Drain any remaining pumped fluid and relieve internal pressure.

2. Remove safety guards and loosen adjusting bolts and nuts on the packing gland.

3. Remove worn packing rings using the appropriate extraction tools.