Trane Series R™ Helical Rotary Chiller RTAC275X

Perform all weekly maintenance procedures

Attach vacuum hoses to evaporator service valves (one per circuit)

Attach charging hoses to the charging port on the liquid line filter (one per circuit)

Begin semi-automatic vacuum procedure

When vacuum is complete (indicated), manually isolate the unit from vacuum

Charge unit through the filter housing port per Table 1 - Table 4

When charging is complete, shut evaporator service valve

Disconnect vacuum and charging hoses

Proper oil and refrigerant charge is essential for proper unit operation, unit perfor-mance, and environmental protection. Only trained and licensed service personnal should service the chiller.

Some symptoms of a refrigerant under-charged unit:

• Higher than normal discharge superheat

• Larger than normal evaporator approach temperatures (leaving water temperature - saturated evaporator temperature)

• Low evaporator refrigerant temperature limit

• Low refrigerant temperature cutout diagnostic

Inspect the individual pieces of the shipment for obvious damage

Inspect the unit for concealed damage

If concealed damage is discovered, stop unpacking the shipment.

Provide evidence that the damage did not occur after delivery

Notify the carrier’s terminal of the damage immediately, by phone and by mail

Notify the Trane sales representative and arrange for repair

Do not repair the unit until damage is inspected by the carrier’s representative.

Sign off on the inspection checklist

Manually open EXV for 15 minutes to allow refrigerant to drain to evaporator by gravity (ensure water is flowing in the evaporator prior to opening the EXV)

Let unit sit with heaters on to drive refrigerant out of oil and warm up compressor bearings. Depending upon ambient conditions, this may take up to 24 hours.Ensure the UCM is powered so the pump may be energized if it detects a freeze condition

Once the oil level has returned to normal, the unit can be put back into operation