Trane CenTraVac™ Water-Cooled Chiller CVHF - 350-570 - 588 - 050S / 080S

- Check the chiller’s evaporator and condenser pressures, oil tank pressure, differential oil pressure, and discharge oil pressure

- Compare the readings with the values provided in the general maintenance

- Check the oil level in the chiller oil sump using the two sight glasses provided in the oil sump head. When the unit is operating, the oil level should be visible in the lower sight glass

- Complete logs on a daily basis.

- Shut down the chiller once each year to check the items for Leak Test Chiller

1. Check purge times and unit performance logs. If warranted, pressure leak test

2. Review oil analysis. If required, submit refrigerant sample for analysis

3. Inspect unit for any signs of refrigerant or oil leakage

4. Check unit for any loose screws on flange, volutes, or casing

Failure to follow safe leak test procedures below could result in death or serious injury or equipment or property-only-damage

Never use an open flame to detect gas leaks. Use a leak test solution for leak testing

- Shut down the chiller once each year to check the items of Evaporator

1. Inspect for fouling and scaling in tubes

2. Check operation of evaporator water flow sensing device

3. Factory recommendation to eddy current test tubes every three years;

- Shut down the chiller once each year to check the items of Starter or Adaptive FrequencyTM Drive

2. Check all connections per manufacturer specifications

3. Follow all manufacturer recommendations for starter or Adaptive FrequencyTM Drive (AFD) maintenance

4. Inspect/clean/service the AFD cooling system (water- or air-cooled AFD)

5. Record all applicable starter or starter component settings;

- Lubricate the vane control linkage bearings, ball joints, and pivot points

- Lubricate vane operator tang O- rings

- Lubricate the oil filter shutoff valve O-rings;