SULLAIR Water-Cooled Compressor 10B 30HP-251330-003 WC

Check the fluid level in the sump. Should the level be low, simply add the necessary amount

Observe the gauges and indicators to be sure they monitor the correct readings for that particular phase of operation

Check on the overall compressor and gauges to assure that the compressor is running properly after it has warmed up

Clean the return line strainer after the initial 50 hours of operation

Clean the return line orifice after the initial 50 hours of operation

Sign off on the daily compressor maintenance

Order separator element repair kit number 250034-112 for 25 and 30HP compressors and repair kit number 250034-114 for 40HP compressors.

Relieved all pressure from the sump tank and all compressor lines?

Disconnected all piping connected to the sump cover to allow removal (return lines, service lines, etc.)?

Loosened and removed the hex head capscrews from the cover plate?

Lifted the cover plate from the sump?

Scraped the old gasket material from the cover and flange on the sump without letting the scraps fall in the sump?

Installed the new gaskets; one on the sump tank the other on top of the element?

Reinserted the separator element into the sump without denting it against the tank opening?

Replace the fluid filter element

Replace your fluid filter element and the gasket under any of the following conditions, whichever occur first

Conditions for replacing fluid filter element

To replace fluid filter element:

Using a strap wrench, remove the old element and gasket

Apply a light film of fluid to the new gasket

Hand tighten new element until new gasket is seated in the gasket groove

Warning: This inspection requires trained personnel with PPE!

Bright light test for damage or leak holes

Gaskets and gasket contact surfaces inspection

If faulty gaskets are found, correct the condition immediately

Clean element stored in a clean container?

All air inlet connections inspected and tightened

Sign off on the air filter element inspection

Clean exterior of air filter housing

Remove the air filter cover by loosening the wingnut securing the cover

Remove element and clean interior of housing using a damp cloth. DO NOT blow dirt out with compressed air

Reset the filter maintenance indicator

Sign off on the air filter element replacement