SULLAIR Vacuum System VS32-150/A

Warning: Only use a replacement fluid filter identified with the Sullair name, logo and appropriate part number.

Old element and gasket removed with a strap wrench?

Gasket seating surface cleaned?

Light film of fluid applied to the new gasket?

New element hand tightened until new gasket is seated in the gasket groove without any nicks, cuts or pinches?

Element tightened by hand an additional 1/2 to 3/4 turn?

Vacuum restarted and checked for leaks?

Sign off on the fluid filter maintenance

Warning: Drainage and fill-up of lubricant from the cooler core must be done separately from the separator tank; the thermal valve isolates the connecting pipework. Please use the provided filler (outlet manifold), drain (outlet manifold) and breather (inlet manifold) plugs for these tasks.

Cleaned the return line strainer?

Lubricated the Sullicon Control linkage?

Drained the sump and changed the vacuum pump fluid?

Sign off on the 4000 Hourly Vacuum System Maintenance

Air filter maintenance should be performed every six (6) months or when indicated by the inlet vacuum gauges.

Clean exterior of air filter housing.

Remove the air filter cover by loosening the clamps securing the cover.

Clean debris from inside filter housing prior to removing element.

Remove element and clean the base and interior of cover using a damp cloth. DO NOT blow dirt out with compressed air.

At this time, replace the element.

Sign off on the air filter maintenance

Warning: This procedure requires trained personnel!

Enter the current operating vacuum

Is the operating vacuum at 20 in-Hg (508mm)?

If not, adjust the vacuum regulator

Is the jam nut on the vacuum regulator loose?

Did you adjust the screw clockwise to increase the setting or counterclockwise to decrease the setting?

Is the new operating vacuum at 20 in-Hg (508mm)?

Place a bright light inside the element to inspect for damage or leak holes. Concentrated light will shine through the element and disclose any faulty areas.

Inspect all gaskets and gasket contact surfaces of the housing. Should faulty gaskets be evident, correct the condition immediately.

If the clean element is to be stored for later use, it must be stored in a clean container.

After the element has been installed, inspect and tighten all air inlet connections prior to resuming operation.

Sign off on the element inspection