SULLAIR Industrial Rotary Screw Air Compressor TS32SC-500/600WCAC

NOTE! A fluid sample at every 1000 hours is recommended

1. For a free Sullube analysis, send fluid to

1.2 Lubricant Technology Center

2. To facilitate this, a sample bottle is included with the compressor;

Clean the return line strainers

Lubricate the Sullicon Control linkage

Replace the fluid filter element

Sign off on the maintenance completion

WARNING! DO NOT remove caps, plugs, and/or other components when compressor is running or pressurized. Stop compressor and relieve all internal pressure before doing so

Check the fluid level in the sump

Observe the Supervisor control panel and be sure it monitors the correct readings for that particular phase of operation

After the compressor has warmed up, it is recommended that a general check of the overall compressor and Supervisor be made to assure that the compressor is running properly

Sign off on the daily industrial rotary screw air compressor service

WARNING! Disconnect all power at source before attempting maintenance or adjustments

Check alignment per Step 3. If operation limits from Table 7-1 Installation Data are exceeded, realign coupling to installation limits

Check outer blades of discpacks near bushings for fatigue cracks. Discpacks can be checked while coupling is in operation by using a strobe light. Replace cracked discpacks and recheck alignment. A slight bowing or “S”-like distortion is normal

Check tightening torques of all drive bolts

STEP 1- HUB INSTALLATION. MOTOR HUB INSTALLATION FOR MOTOR HUB MOUNTING

Coupling is furnished for an interference fit with a set screw. Heat hub to 275oF (135oC) using an oven, torch, induction heater or an oil bath

When an oxy-acetylene or blow torch is used, use an excess acetylene mixture. Mark hubs near the center of their length in several places on hub body with a temperature sensitive crayon, 275oF (135oC) melt temperature. Direct flame towards hub bore using constant motion to avoid overheating an area

Heat hubs as instructed above. Mount hubs as quickly as possible with hub flange face flush with shaft end. Allow hubs to cool before proceeding. Insert set screws (if required) and tighten

NOTE! DO NOT clean the separator elements

Is a replacement message displayed?

Has it been one year since the last replacement?

Were the separator elements replaced?

Sign off on the separator element replacement