Sullair Industrial Air Compressor 2207

Warning: High-pressure hazard! Do not remove caps, plugs, and/or other components when compressor is running or pressurized. Stop compressor and relieve all internal pressure before doing so. Failure to comply could result in death or serious injury.

Fluid level in the separator/sump tank is adequate

If fluid level is low, note down the amount of fluid added

Is the addition of fluid becoming too frequent?

If the addition of fluid becomes too frequent, refer to Section 6.9: Troubleshooting—Introduction on page 61 under EXCESSIVE COMPRESSOR FLUID CONSUMPTION for a probable cause and remedy.

Controller display monitors the correct readings for their particular phase of operation

Compressor is running properly after warming up

Sign off on the daily compressor inspection

Warning: Do not mix different types of fluids.

Contamination of non-detergent mineral fluids with traces of detergent motor fluids may lead to operational problems such as foaming, filter plugging, orifice or line plugging.

Note: Flush system when switching lubricant brands.

When ambient conditions exceed those noted or if conditions warrant use of 'extended' life lubricants contact Sullair for recommendation.

Drained the separator/sump tank?

Participated in a fluid analysis program with the fluid suppliers?

Enter the details of the fluid analysis program

Maintenance indicator shows red with the compressor running full load?

If the filter needs to be replaced, order a replacement element.

Clean exterior of air filter housing.

Rotate end cover counterclockwise and remove.

Remove air filter element by pulling it out of the housing.

Clean interior of housing using a damp cloth. DO NOT blow dirt out with compressed air.

At this time replace the element.

Reassemble in the reverse order of the disassembly.

Sign off on the air filter replacement

Warning: This procedure requires trained personnel with PPE!

Is the strainer screen damaged?

If the screen is damaged, replace the strainer assembly (P/N 241772)

Upload a photo of the cleaned/replaced strainer screen

Sign off on the strainer cleaning/replacement

Warning: Relieve all pressure from the separator/sump tank and all compressor lines before starting.

Loosen and remove the six (6) hex head cap screws (8.8 M12 x 40 mm) from the cover plate.

Lift the cover plate from the separator/sump tank.

Inspect the separator/sump tank for rust, dirt, etc.

Reinsert the separator element into the separator/sump tank taking care not to dent the element against the tank opening.

Install a new O-ring in the O-ring groove on the underside of the separator/sump tank cover.

Replace the cover plate, washers and cap screws. Torque to 70 ft·lbs (95 N·m).

Clean the return line strainer before restart.