SPX Flow Centrifugal Pump WS+44/50

To minimize the risk of this hazard:

All electric/electronic installation, maintenance, and service must be performed by trained and authorized electricians only.

To minimize the risk of this hazard:

1. All installation, maintenance, and service of piping, valves, and other controls must be performed by trained and authorized plumbers only.

This applies to process piping and cleaning/sanitizing piping.

2. All plumbing installation must comply with all applicable codes and standards including those established by OSHA.

3. Do Not perform any maintenance or service on the motor or pump unless the power source has been turned off and Locked Out, where only the person involved in the maintenance procedure has possession of the key.

4. Never disconnect any lines or fittings (whether process or cleaning/ sanitizing) or disassemble the pump until the line is no longer under pressure and the fluid inside is not hot or harmful.

Safety Information! All electric/electronic installation, maintenance, and service must be performed by trained and authorized electricians only.

All installation, maintenance, and service of piping, valves, and other controls must be performed by trained and authorized plumbers only.

All plumbing installation must comply with all applicable codes and standards including those established by OSHA.

Do Not perform any maintenance or service on the motor or pump unless the power source has been turned off and Locked Out.

Never disconnect any lines or fittings or disassemble the pump until the line is no longer under pressure and the fluid inside is not hot or harmful.

Operating personnel must be authorized and trained.

Always clean up leaks and spills immediately.

Find and correct the cause of the leak immediately.

Lock Out power supply then disconnect the pump and motor from system.

Safety Information! All electric/electronic installation, maintenance, and service must be performed by trained and authorized electricians only.

All installation, maintenance, and service of piping, valves, and other controls must be performed by trained and authorized plumbers only.

All plumbing installation must comply with all applicable codes and standards including those established by OSHA.

Do Not perform any maintenance or service on the motor or pump unless the power source has been turned off and Locked Out.

Never disconnect any lines or fittings or disassemble the pump until the line is no longer under pressure and the fluid inside is not hot or harmful.

Operating personnel must be authorized and trained.

Always clean up leaks and spills immediately.

Find and correct the cause of the leak immediately.

Check the pump's shaft seal for leaks

Safety Information! All electric/electronic installation, maintenance, and service must be performed by trained and authorized electricians only.

All installation, maintenance, and service of piping, valves, and other controls must be performed by trained and authorized plumbers only.

All plumbing installation must comply with all applicable codes and standards including those established by OSHA.

Do Not perform any maintenance or service on the motor or pump unless the power source has been turned off and Locked Out.

Never disconnect any lines or fittings or disassemble the pump until the line is no longer under pressure and the fluid inside is not hot or harmful.

Operating personnel must be authorized and trained.

Always clean up leaks and spills immediately.

Find and correct the cause of the leak immediately.

Pump is working properly after pouring water into it and starting it for a moment.