Scott Self-Contained Breathing Apparatus SKA-PAC

NOTE: THIS REGULATOR CHECK IS NOT INTENDED TO BE A COMPLETE FUNCTIONAL CHECK OF THE RESPIRATOR. BEFORE NEXT USE, PERFORM A REGULAR OPERATIONAL INSPECTION AS DESCRIBED IN THESE INSTRUCTIONS.

Respirator cylinder is at least 1/4 full

Donning/air saver switch is fully depressed

Regulator is reattached to the respirator (if removed for cleaning)

Cylinder valve is opened at least one (1) full turn

No air flow from the regulator is heard

If air flow from the regulator is heard, close the cylinder valve, repeat steps 1, 2 and 3. If air flow is still heard, close the cylinder valve fully, tag unit for repair and remove from service.

Open the purge valve and observe the air flow from the regulator spray bar. No droplets of water are present

Warning: Only SCOTT Authorized Service Center personnel should perform this check

Respirator functionally checked

Sign off on the respirator maintenance

Warning: Do not attempt to replace components or make adjustments or repairs without proper training.

Inspect the equipment for worn or aging rubber parts, worn or frayed harness webbing or damaged components.

If the SKA-PAK PLUS respirator is equipped with the full body/fall protection harness, inspect the harness for frayed or damaged webbing or damaged buckles.

If any damage to the harness is found, do not use the full body/fall protection harness.

Remove the breathing regulator from the facepiece by pulling back on the regulator retaining latch and rotating the regulator 1/4 turn.

Clean the respirator according to CLEANING THE RESPIRATOR section of this instruction. The unit must be thoroughly dry before storage.

Inspect the gasket on the breathing regulator that seals against the facepiece for rips or damage that may break the seal.

Connect the breathing regulator to the facepiece and rotate until it latches into place. Verify that the latch securely snaps into the notch on the facepiece.

Perform the REGULAR OPERATIONAL INSPECTION described in this instruction manual.

Cylinder hydrostatic test date current

Cylinder and valve assembly inspected for physical damage

Cylinder gauge indicates 'FULL'

Cylinder attachment to the harness inspected

Full body/fall protection harness inspected for damage

NOTE: AFTER CLEANING THE REGULATOR, VERIFY THAT ALL MOISTURE HAS BEEN REMOVED FROM THE REGULATOR AS DESCRIBED IN THE REGULATOR CHECK SECTION OF THIS INSTRUCTION.

Remove the breathing regulator from the facepiece by pulling back on the locking clip and rotating the regulator 1/4 turn clockwise.

Remove any obvious dirt from the external surfaces of the regulator using SCOTT recommended sanitizing or disinfecting cleaner with a sponge or soft cloth.

Inspect the inside of the regulator assembly through the regulator opening. If excessive dirt or soil is present, forward regulator assembly to SCOTT trained authorized personnel for thorough cleaning.

Depress the donning/air saver switch, close the purge knob by turning fully clockwise. Use the SCOTT recommended sanitizing or disinfecting cleaner in the regulator opening and the immediate area around the opening. Be sure to cover internal components completely.

Follow the user instructions for the SCOTT recommended cleaner. A specific contact time may be required for sanitizing or disinfecting before rinsing.

Rinse the regulator with drinking water using a spray bottle or gently running tap water.

Shake excess water out of regulator. Completely air dry the regulator before use.

NOTE: TO SPEED DRYING OF THE REGULATOR, GENTLY BLOW DRY WITH CLEAN, DRY BREATHING AIR OF 30 PSIG MAXIMUM. DO NOT USE SHOP AIR OR ANY OTHER AIR CONTAINING LUBRICANTS OR MOISTURE.