Rytec Insulated Roll-Up Door Turbo-Seal

NOTE: The following maintenance schedule is recommended for the Rytec Cycle-Plus maintenance program.

Visual Damage Inspection: Check for any visible damage to the door components (e.g., bent bottom bar assembly, torn fabric panel, damage to side columns, etc.)

Head Assembly: Inspect for dents or damage that may prevent the door from opening or closing properly.

Door Panel: Inspect panel for holes, tears, and worn areas. If equipped with windows, inspect them for damage or dirt that may impair vision — clean or replace as required.

Side Columns and Covers: Inspect for damage that may prevent the door from operating properly.

Photo Eyes: Inspect the lens of each photo eye for damage or dirt that may prevent the photo eyes from working properly — clean or replace as required.

Warning Lights: Inspect the lens of each light for damage or dirt that may prevent the lights from working properly — clean or replace as required.

Bottom Bar: Inspect the bottom bar for damaged, missing, or loose hardware. Inspect the black vinyl seal along the lower edge of the bottom bar for tears and holes. Inspect the edge itself.

Counterweights and Straps: Counterweights must be properly adjusted. Counterweight straps must be in good working condition, securely attached to the counterweights and the drum assembly, and tracking properly on all rollers.

Pathwatch LED warning lights act as a safety device to warn personnel that the door is closing. The warning lights are not a door activator or opener.

Raise the door to the fully open position by pushing the up arrow key on the front of the control panel.

Press the down key on the front of the control panel.

As the door is closing, the amber and red warning lights will flash.

Repeat the procedure on the opposite side of the door.

Sign off on the Pathwatch LED inspection

NOTE: Photo eyes act as a safety device to prevent the door from closing if an object or person is within the photo eye beam. The photo eyes are not meant to be used as door activators.

Raise the door to the fully open position by pushing the up arrow key on the front of the control panel.

Break the beam of light on the front side of the door by placing an object between the photo eyes, transmitter and receiver.

Press the down arrow key on the front of the control panel. The door should not operate.

If the photo eyes don’t operate properly, the transmitter or receiver may be dirty. Clean as required using window cleaner and a clean, soft cloth. If cleaning does not solve the problem, see “PHOTO EYE ADJUSTMENT” on page 15 for adjustment procedures.

Repeat the procedure on the back side of the door.

Sign off on the photo eye inspection

Inspect all warning and safety labels. All labels should be intact, clean, and clearly legible. Replace any label when necessary.

Operate the door five or six complete open and close cycles with each activator installed with the door. Make any necessary adjustments or repairs. Refer to the associated manual supplied with each activator installed with your door.

Typical activators may include a floor loop, pull cord, push button, motion detector, radio control, or photo eye. The door open cycle is controlled by the activator. The door close cycle can be controlled by an activator or by a timer internal to the control panel.

Check the control panel for proper operation. If an adjustment or repair is necessary, refer to the Rytec System 4 Drive & Control Installation & Owner’s Manual that was shipped with your control panel.

Inspect all hardware used to secure the breakaway assembly to the bottom bar. Tighten hardware as required.

Inspect the reversing edge to ensure that it is tightly secured to the bottom bar. Tighten hardware as required.

Inspect the black vinyl seal along the bottom bar assembly for tears and abrasion. Replace any worn or damaged parts as required.

Upload a photo of the bottom bar assembly

Sign off on the bottom bar inspection