Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Rosemount Transmitter 8712EM

Create an account to install this asset package.

Maintenance Plans for Rosemount Transmitter Model 8712EM

Integrate maintenance plans directly into your work orders in MaintainX.

Terminal Block With Amp Clips Replacement

Removing a terminal block

Procedure

1. Disconnect power to the transmitter.

2. Remove the junction box cover on the sensor to gain access to the remote cabling and disconnect the remote cabling connected to the terminal block.

3. To disconnect the terminal block from the junction box housing, remove the two mounting screws and the two divider mounting screws (if applicable).

4. Pull up on the terminal block to expose the connecting wires.

5. To remove the terminal block, unclip both wire connectors.

Installing a terminal block

Procedure

Run this procedure

Terminal Block Socket Module Replacement

Removing a terminal block socket module

Procedure

1. Disconnect power to the transmitter and the remote cabling connected to the terminal block.

2. Remove the junction box cover to gain access to the remote cabling.

3. To disconnect the terminal block from the junction box housing, remove the two mounting screws and the two divider mounting screws (if applicable).

4. Pull up on the terminal block to expose the socket module base.

5. To remove the socket module, loosen the two mounting screws and pull up on the socket module from the base.

6. When removing the socket module, do not pull on the wires.

Installing a terminal block socket module

Run this procedure

Electronic Stack Replacement

Prerequisites

Make sure that the replacement board stack matches the existing stack. There are two ways to make sure:

• Look at the complete transmitter model number. Current (Revision 4) electronics are only compatible with Models 8712EM. If your transmitter model number as shown on the model number tag is not 8712EM, you cannot use a Revision 4 board stack.

• Visually inspect the existing and new electronics stacks to ensure that they are physically alike. The older version of the electronics stack was rectangular; the current (Revision 4) electronics stack is circular.

Procedure

1. If the transmitter is installed in a control loop, secure the loop.

2. Remove power from the transmitter.

3. Loosen the upper door screw and open the top electronics compartment of the transmitter housing.

4. Carefully unplug each of the connectors from the top of the electronics stack: LOI/Display (if equipped), coil, and electrode.

Run this procedure