Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Roberts-Gordon Infrared Heater BH-40

Create an account to install this asset package.

Maintenance Plans for Roberts-Gordon Infrared Heater Model BH-40

Integrate maintenance plans directly into your work orders in MaintainX.

1 Yearly Gas Piping Inspection

SECTION 9: GAS PIPING

WARNING: Fire Hazard

Gas hose fittings tightened according to Figure 23

Gas hose not cracked or twisted

Gas hose moves during normal operation

36\ (91 cm) long connector of 1/2\" or 3/4\" nominal ID used"

WARNING: Explosion Hazard

Gas hose installed as shown on Page 46, Figure 24

High pressure testing of the gas piping completed

Run this procedure

1 Yearly Heater Vicinity Inspection

The Vicinity of the Heater

Do not store or use flammable objects, liquids, or vapors near the heater

Immediately remove these items if they are present

Vehicles and Other Objects

Maintain the clearances to combustibles

Do not hang anything from, or place anything on, the heater

Make sure nothing is lodged underneath the reflector, in between the tubes, or in the decorative or protective grilles included with select models

Immediately remove objects in violation of the clearances to combustibles

See Page 5, Section 3

Run this procedure

1 Yearly Reflector Inspection

Reflector

Reflector supported with hanger and strap

Reflector not touching tube

No dirt, sagging, cracking, or distortion on reflector

Reflector correctly overlapped

Upload a photo of the reflector

Reflector, U-Clip and Reflector Support Installation

First reflector after burner slid minimum 2” (4 cm) through first hanger

Reflector end cap securely fastened

Run this procedure

1 Yearly Thermostat Inspection

SECTION 10: WIRING DANGER - Electrical Shock Hazard - Disconnect electric before service - Heater must be properly earthed - Failure to follow these instructions can result in death or electrical shock

No exposed wire or damage to the thermostat

Heaters can be controlled using several methods. Normally thermostats are used to control the heaters but they can also be controlled by an energy management system.

Choose the connection for heaters

Heaters must be grounded in accordance with applicable codes: United States: Refer to National Electrical Code® NFPA 70 - latest revision Canada: Refer to Canadian Electrical Code CSA C22.1 Part I - latest revision

Internal wiring replaced with wiring materials having a temperature rating of at least 105 °C and 600 volts

Sign off on the thermostat inspection

Run this procedure

1 Yearly Tubes Inspection

Tubes.; Make sure there are no cracks.; Make sure tubes are connected and suspended securely.; See Page 16, Section 6.; Make sure there is no sagging, bending, or distortion.; Clean or replace as required.; SECTION 6: HEATER INSTALLATION

WARNING

Severe Injury Hazard

Secure burner to burner tube with nuts and lockwashers

Hang heater with materials with a minimum working load of 75 lbs (33 kg)

Failure to follow these instructions can result in death, injury or property damage

WARNING

Cut/Pinch Hazard

Wear protective gear during installation, operation and service

Run this procedure