Ram Car Promaster 3500

WARNING! You can be badly injured working on or around a motor vehicle. Do only service work for which you have the knowledge and the right equipment. If you have any doubt about your ability to perform a service job, take your vehicle to a competent mechanic.

Failure to properly inspect and maintain your vehicle could result in a component malfunction and affect vehicle handling and performance. This could cause an accident.

Enter the current mileage of the vehicle

Engine coolant flushed and replaced

PCV valve inspected and replaced if necessary

Sign off on the 10 Yearly Car Maintenance

Check windshield washer fluid level

Look for unusual tire wear or damage

Rotate tires at the first sign of irregular wear

Check the fluid levels of the coolant reservoir

Check the fluid levels of the brake master cylinder

Check function of all interior and exterior light

NOTE: The proper cold tire inflation pressure is listed on the driver’s side B-pillar or the rear edge of the driver's side door.

Check the inflation pressure of each tire, including the spare tire (if equipped), at least monthly and inflate to the recommended pressure for your vehicle.

This placard tells you important information about the: 1. Number of people that can be carried in the vehicle. 2. Total weight your vehicle can carry. 3. Tire size designed for your vehicle. 4. Cold tire inflation pressures for the front, rear, and spare tires.

The proper cold tire inflation pressure is listed on the driver's side B-pillar or rear edge of the driver's side door.

At least once a month: • Check and adjust tire pressure with a good quality pocket-type pressure gauge. Do not make a visual judgment when determining proper inflation. Tires may look properly inflated even when they are under-inflated.

• Inspect tires for signs of tire wear or visible damage.

CAUTION!: After inspecting or adjusting the tire pressure, always reinstall the valve stem cap. This will prevent moisture and dirt from entering the valve stem, which could damage the valve stem.

Inflation pressures specified on the placard are always “cold tire inflation pressure”. Cold tire inflation pressure is defined as the tire pressure after the vehicle has not been driven for at least three hours, or driven less than 1 mile (1.6 km) after sitting for a minimum of three hours. The cold tire inflation pressure must not exceed the maximum inflation pressure molded into the tire sidewall.

WARNING! You can be badly injured working on or around a motor vehicle. Do only service work for which you have the knowledge and the right equipment. If you have any doubt about your ability to perform a service job, take your vehicle to a competent mechanic. Failure to properly inspect and maintain your vehicle could result in a component malfunction and affect vehicle handling and performance. This could cause an accident.

Inspect the CV/Universal joints

Inspect front suspension, tie rod ends, and replace if necessary

Inspect the brake linings, replace as necessary

Inspect the cabin air filter, replace as necessary

Replace the Brake Fluid every two years. The brake fluid change interval is time based only, mileage intervals do not apply.

Sign off on the car maintenance

Warning: This procedure requires trained personnel!

Enter the current engine run time in hours

Enter the date of the last oil change

Is the 'Oil Change Required' message displayed in the instrument cluster?

If the 'Oil Change Required' message is displayed, service the vehicle within the next 500 miles (805 km)

Enter the name of the authorized dealer who will perform the oil change

Upload a photo of the instrument cluster display after the oil change

Sign off on the oil change procedure