Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

R&M Materials Handling Chain Hoist LK16

Create an account to install this asset package.

Maintenance Plans for R&M Materials Handling Chain Hoist Model LK16

Integrate maintenance plans directly into your work orders in MaintainX.

1 Daily Lift Chain Inspection

General condition of the hoist

Operating environment free of new hazards

No oil leaks from the product

Chains free of deformation, damage or twists

Chains clean and correctly lubricated

Load hook free of nicks, gouges, deformation of the throat opening, wear on the saddle or load bearing point, and twisting

Hook rotates freely

All warning signs are in place, in good condition, and can be read easily

Product is not locked or tagged out

Run this procedure

1 Monthly Chain Hoist Check

Check the cleanness and lubrication of chain

Check the operation of slipping clutch

Check the operation of the motors

Sign off on the chain hoist check

Run this procedure

1 Monthly Chain Lubrication

Warning: Use only lubricants recommended by the product’s manufacturer. See the lubricant tables for more information

Note: Equipment may have synthetic lubricant as a factory installed lubricant. Please refer to order confirmation

Used only fresh oils/greases?

Different kinds of greases not mixed up?

Handle lubricants carefully. Prevent leakages to waters, sewers, cellars and other closed places

Kept lubricants away from heat and open fires?

Avoided contact with skin?

Wore protection gloves and safety goggles when handling lubricants?

Kept lubricants away from food and drink?

Run this procedure

1 Yearly Brake System Inspection

NOTE! For accessing the control electrics and brake, remove the end cover as follows

1. Remove the cover

2. Locate the check hole in brake assembly

3. Measure the gap with a caliper

NOTE! Note that the brake measurement value varies according to manufacturer and brake series. For each case, the maximum value that is not to be exceeded is indicated in the brake sticker located on the brake

Checking the brake lining: Secondary brake (double brake option)!

The secondary brake, located in the double brake assembly that is available as an optional feature, works only as a back-up brake for the main brake. It will be the functional brake only, if the main brake is damaged in a way that it cannot hold the load. If the main brake operates normally, there is no need to check the wear on the secondary brake;

Run this procedure

1 Yearly Chain Hoist Inspection

Check the condition of the fixing of the covers

Measure the wear of the chain

Check the condition of the rubber pad in the idle end of the chain (inside the chain bag)

Check the condition and readability of the warning etc. stickers

Check the readability of the instructions

Check the validity of the log book

Sign off on the chain hoist inspection

Run this procedure