Mohawk Lifts Post Truck Lift TP-30-WB

Pre-operation check list performed

Report any and all equipment malfunctions

Light lubricant used if oxidization is occurring

Area around equipment free of dirt, sand, water, etc.

Sign off on the daily post truck lift maintenance

Inspect all hydraulic components for leaks, deformation, wear or corrosion

Tighten all fasteners, hydraulic / pneumatic fittings as required

All O - Ring boss fittings jam nuts are to be tightened to 15 foot pounds torque

All pipe fittings, if leaking are to be removed, re-sealed, and re - installed. ( Select - Unite thread sealant or equivalent on fitting threads )

Inspect mounting bolt conditions for any possible corrosion

Inspect the floor for any signs of fatigue or fractures

Sign off on the truck lift maintenance

Perform the daily operation check list

Perform the hydraulic safety checks

Wipe clean, the cylinders' wiper seals and the base of each post to remove any weeping oil and dust

Verify fluid level. With the unit fully lowered, the fluid level will be 1/2 inch below the breather cap port. Use Dexron III as replacement fluid

Lubricate the arm restraint assemblies as needed to insure free, and smooth operation. (Do not use grease)

Cycle unit to full height, and bleed approximately 30 seconds

Check lubricator fluid level. Fill if needed

Drain filter regulator of excessive moisture

Sign off on the weekly post truck lift maintenance

Check your hydraulic fluid annually

Inspect all bearings for unusual or excessive wear

Remove the swing arm restraints

Perform the daily, weekly, and monthly maintenance procedures

Sign off on the 1 Yearly Post Truck Lift Maintenance

QUALIFY / RE-QUALIFY ALL PERSONNEL IN THE SAFE OPERATION OF THIS UNIT.

ANCHORS (SEE ANCHOR SPECIFICATION SECTION)

LOCK BODY MAIN PIVOT PINS LUBRICATED AND MOVING SMOOTHLY

CHANNEL SECTIONS WHERE THE CARRIAGE BEARINGS RIDE AGAINST CLEANED AND LUBRICATED

MAIN CARRIAGE BEARINGS ARE FACTORY LUBRICATED AND SEALED