Mohawk Lifts Post Truck Lift TP-26-WB

Pre-operation check list performed

Report any and all equipment malfunctions

If oxidization is occurring, use a light lubricant (WD-40 or equivalent)

Area around this equipment free of dirt, sand, water, etc.

Sign off on the daily post truck lift maintenance

Inspect all hydraulic components for leaks, deformation, wear or corrosion

Tighten all fasteners, hydraulic / pneumatic fittings as required

All O - Ring boss fittings jam nuts are to be tightened to 15 foot pounds torque

All pipe fittings, if leaking are to be removed, re-sealed, and re - installed. ( Select - Unite thread sealant or equivalent on fitting threads )

Inspect mounting bolt conditions for any possible corrosion

Inspect the floor for any signs of fatigue or fractures

Sign off on the truck lift maintenance

Perform the daily operation check list

Perform the hydraulic safety checks

Wipe clean, the cylinders' wiper seals and the base of each post to remove any weeping oil and dust

Verify fluid level. With the unit fully lowered, the fluid level will be 1/2 inch below the breather cap port

Lubricate the arm restraint assemblies as needed to insure free, and smooth operation. (Do not use grease)

Cycle unit to full height, and bleed approximately 30 seconds

Check lubricator fluid level. Fill if needed

Drain filter regulator of excessive moisture

Sign off on the weekly post truck lift maintenance

Replace and re-bleed the hydraulic fluid every five years

Inspect all bearings for unusual or excessive wear

Remove the swing arm restraints

Clean the swing arm restraints thoroughly

Use a light lubricant (WD-40 or equivalent) on the swing arm restraints

QUALIFY / RE-QUALIFY ALL PERSONNEL IN THE SAFE OPERATION OF THIS UNIT

ANCHORS (SEE ANCHOR SPECIFICATION SECTION)

LUBRICATE LOCK BODY MAIN PIVOT PINS

CLEAN AND LUBRICATE CHANNEL SECTIONS WHERE THE CARRIAGE BEARINGS RIDE AGAINST

THE MAIN CARRIAGE BEARINGS ARE FACTORY LUBRICATED AND SEALED. THEY DO NOT REQUIRE ANY ADDITIONAL PERIODIC LUBRICATION