Manitowoc Refrigeration Equipment UDF0240A

Preparation and Safety Precautions

Ensure the ice machine is turned off after ice falls from the evaporator or allow ice to melt off the evaporator.

Press the Clean button to start the descaling cycle.

Add the proper amount of ice machine cleaner/descaler to the water trough

Wait until the cycle is complete, then disconnect power and water supplies.

Disconnect electric power to the ice machine head section and the remote condensing unit at the electric service switches

Handle condenser fins with care to avoid injury

Shine a flashlight through the condenser to check for dirt between the fins

Blow compressed air through the condenser from the inside out

Rinse the condenser with water from the inside out

Water Fittings and Lines Inspection

Check all water fittings for leaks

Check all water lines for leaks

Refrigeration Tubing Inspection

Ensure refrigeration tubing is not rubbing against other tubing

Ensure refrigeration tubing is not vibrating against panels

Ensure nothing is placed in front of the ice machine

Verify adequate airflow through and around the ice machine

Clean the area around the ice machine to maintain cleanliness and efficient operation.

Sponge any dust and dirt off the outside of the ice machine with mild soap and water.

Wipe dry with a clean, soft cloth.

Cleanup any fallen ice or water spills as they occur.

Wear rubber gloves and safety goggles (and/or face shield) when handling Ice Machine Cleaner/Descaler or Sanitizer.

Press the On/Off button after ice falls from the evaporator at the end of a Harvest cycle or allow the ice to melt off the evaporator.

Ensure no tools are used to force ice from the evaporator to prevent damage.

Press the Clean button to start a cycle.

Wait until the water trough refills, then add the proper amount of ice machine cleaner/descaler to the water trough.

Wait until the cycle is complete (approximately 22 minutes) then press the On/Off button.