Lincoln Vehicle Navigator L

Change the automatic transmission fluid.

Change the front axle fluid - Four-wheel drive vehicles.

Change the transfer case fluid - Four-wheel drive vehicles.

Replace the accessory drive belt(s).

1. Make sure that your vehicle is on level ground.

2. Check the oil level before starting the engine, or switch the engine off after warm up and wait 15 minutes for the oil to drain into the oil pan.

Note: Checking the oil level too soon could result in an inaccurate reading.

3. Remove the dipstick and wipe it with a clean, lint-free cloth.

4. Reinstall the dipstick and make sure it is fully seated.

5. Remove the dipstick again to check the oil level.

Change the engine oil and filter

Rotate the tires, inspect tire wear and measure tread depth

Perform a multi-point inspection

Inspect the automatic transmission fluid level

Inspect the brake pads, rotors, hoses and parking brake

Inspect the engine cooling system strength and hoses

Inspect the exhaust system and heat shields

Inspect the front axle and U-joints

Warning: Brake fluid servicing requires special equipment available at your authorized dealer.

Is the special equipment available?

If the special equipment is not available, stop the procedure and contact your authorized dealer.

Brake fluid replaced successfully?

Sign off on the brake fluid replacement

Moderate to heavy load or towing

Mountainous or off-road conditions

At Every Oil Change Interval as Indicated by the Information Display

Change the engine oil and filter. - Do not exceed one year or 10,000 mi (16,000 km) between service intervals.

Rotate the tires, inspect tire wear and measure tread depth.

Perform a multi-point inspection - recommended.