LEXMARK Printer E260DN

Check toner level by printing a menu settings page

Open the front door by pressing the button on the left side of the printer and lowering the door

Press the button on the base of the photoconductor kit, and then pull the toner cartridge out using the handle

Rotate the cartridge in all directions to distribute the toner

Install the new toner cartridge by aligning the rollers on the toner cartridge with the arrows on the tracks of the photoconductor kit. Push the toner cartridge in as far as it will go. The cartridge clicks into place when correctly installed

Was the toner cartridge replaced successfully?

Dispose of the old toner cartridge properly

Ensure the printer is turned off and unplugged from the wall outlet

Remove all paper from the printer

Dampen a clean, lint-free cloth with water

Wipe only the outside of the printer

Are all areas of the printer dry?

Order a new photoconductor kit upon receiving the light sequence warning

Removing the Old Photoconductor Kit

Open the front door by pressing the button on the left side of the printer and lowering the front door

Pull the photoconductor kit and toner cartridge out of the printer as a unit

Place the unit on a flat, clean surface

Press the button on the base of the photoconductor kit and remove the toner cartridge

Installing the New Photoconductor Kit

Unpack the new photoconductor kit