Kubota Tractor L245DT

CAUTION: Always check electrolyte level after charging battery. If necessary, add distilled water to maintain proper level.

CAUTION: Check battery terminals to be sure they are clean and free from corrosion. Keeping the battery clean will give prolonged service. Remove corrosion from the terminals periodically and coat terminals with grease.

CAUTION: Maintain the battery at full charge during the winter months to prevent freezing. When water is added during freezing weather, run the engine at least an hour to make sure water and electrolyte have mixed throughly.

CAUTION: Protect against fire and explosion. During refueling never touch battery. This battery is a dry-charged type.

Battery electrolyte level is to the bottom of the filling tube

Battery terminals are clean and free from corrosion

Battery is at full charge during the winter months

Battery is not touched during refueling

Electrode plate separator is not exposed

Cleaning of air cleaner element

Air cleaner of dry element type, therefore oil is not needed

Foreign material such as leaves removed from around the filter

Wing bolt tightened if necessary

Dust cup installed to the air cleaner so as the mark on the cover of the cup points upward

Element cleaned every 100 hours of operation

Air pressure at the nozzle does not exceed 100psi (7kgf/ cm?: 0.69MPa)

Reasonable distance maintained between the nozzle and the filter

Warning: This procedure requires trained personnel with PPE!

Radiator hoses are fastened securely

Radiator hose clamps are sufficiently tightened

If hose clamps are loose, apply oil and retighten to desired tolerance.

Radiator hose replaced at least once every two years

When changing hose also replace clamps.

Radiator hose or clamps appear damaged or worn

If radiator hose or clamps break during operation, boiling. water may escape and cause injury. Be sure to check these items regularly and replace them at once if they appear damaged or worn.

Sign off on the 150 Hourly / 6 Monthly Check

Fuel pipe clamps sufficiently tightened

If pipe clamps are loosened, apply oil and retighten to desired tolerance

Last date of fuel pipe replacement

Fuel pipe is made from rubber and will require periodic replacement. Change at least once every two years. When changing pipe also replace clamps

Air-bleed the system after changing

Sign off on the 150 Hourly Check

Check completely all abnormalities found during previous operation

Air pressure, wear, and general condition of tires

Amount of engine oil and degree of contamination

Amount of transmission oil and degree of contamination

Condition of dust cup in air cleaner

Tractor body for damage, loosened bolts and nuts