Ingersoll Rand Vehicle Turf 1/Carryall 1

- Electrical Vehicle - By owner or trained technician

1) Check/fill transaxle to plug level - 22 oz (0.67 L) SAE 30 WT. API Class SE, SF, or SG Oil (or higher)

2) Inspect front wheel bearings (Repack as necessary) - Chassis Lube – EP NLGI Grade 2.

- Gasoline Vehicle - By owner or trained technician

1) Check/fill unitized transaxle to plug level - 27 oz (0.8 L) 80-90 WT. API Class GL-3 or 80-90 WT. AGMA Class EP Gear Lube

2) Inspect front wheel bearings (Repack as necessary) - Chassis Lube – EP NLGI Grade 2.

- Electrical Vehicle - By owner

Pre-Operation and Daily Safety Checklist

Batteries - Charge batteries (after each daily use only).

Pre-Operation and Daily Safety Checklist

- Electrical Vehicle - By owner or trained technician

Batteries - Wash battery tops and clean terminals with baking soda/water solution.

Tires - Check air pressure and adjust if necessary.

General vehicle - Wash battery compartment and underside of vehicle.

- Gasoline Vehicle - By owner or trained technician

Engine - Check engine oil level, change if necessary.

1. Remove the oil level dipstick from the oil filler tube, and wipe oil off dipstick.

• Do not remove dipstick while engine is running.

- Electrical Vehicle - By trained technician only

Batteries - If batteries are not performing as expected, see the Batteries section in the appropriate maintenance and service manual.

Safety decals - Check safety decals. Replace if damaged or illegible.

- Gasoline Vehicle - By trained technician only

Engine - Check for leaks around gaskets, fill plugs, etc.

Engine - Inspect, clean and gap spark plug, replace if necessary.

Engine air intake system - Check air filter element, clean or replace if necessary.

Engine air intake system - Check clamps for tightness, check hose for cracks.

General vehicle - Check for loose hardware and tighten if necessary.

Warning: Do not attempt to change engine oil when the engine is hot or even warm. Engine oil can cause skin burns. Wear safety glasses or approved eye protection when servicing the vehicle. Wear rubber gloves when handling oil drain plug, oil filter, and oil drain pan.

Turn the key switch to the OFF position, then remove the key. Place the Forward/Reverse handle in the neutral POSITION. Chock the front wheels.

Disconnect battery and spark plug wire(s).

Position a pan designed for oil changes under the front drain plug.

Use a 14 mm socket or wrench to remove the drain plug, turning it counterclockwise, and allow the engine oil to drain into the pan.

Clean the oil drain plug threads with solvent to remove oil and oil residue. Make sure that the compression washer remains on the drain plug.

Use a 14 mm socket or wrench and replace the front oil drain plug, turning it clockwise, and tighten to 18 ft-lb (24.4 N·m).

Relocate the oil drain pan to a position under the engine oil filter.