Ingersoll Rand Compressor N75K Single Stage

Loosen filter element with the correct tool

Remove the element from the housing

Place the old element in a sealed bag and dispose of in a safe way

Clean the mating face of the housing

Remove the new Ingersoll Rand replacement element from its protective package

Apply a small amount of coolant to the element seal

Screw the new element down until the seal makes contact with the housing, then hand tighten a further half turn

Rotate the blower motor several revolutions by hand in the direction of rotation

Pump grease into the bearing while rotating the motor

Is grease visible at the relief port?

Ongoing Maintenance During Storage

Enter the number of months the unit has been in storage

Has the motor been rotated every three months?

Long-term Storage Consideration

Is the storage time expected to exceed nine months?

Ensure compressor is electrically isolated for at least 15 minutes before commencing any maintenance work.

Unclip the front grill of the drive box filter.

Remove the filter pad from the housing.

Replace with a new filter pad from Ingersoll Rand.

Replace front grill to the drive box filter.

Check that all components are in place

Inspect and clean Cooler Core(s)

Inspect and clean Moisture separator

Was the Food Grade Coolant analyzed?

Describe the results of the coolant analysis

Loosen filter element with the correct tool

Remove the element from the housing

Place the old element in a sealed bag and dispose of in a safe way

Clean the mating face of the housing

Remove the new Ingersoll Rand replacement element from its protective package

Apply a small amount of coolant to the element seal

Screw the new element down until the seal makes contact with the housing, then hand tighten a further half turn