Hyster Forklift H10XMS-6

CAUTION: If the air filter container is not cleaned during maintenance or replacement of the air filter, dirt will gradually build up in the filter housing. This may cause the filter unit to function incorrectly. If the filter element has been forced into place, the filter housing can crack over time, allowing dirt to enter into and damage the engine.

Air Flow Restriction Indicator Light on the instrument panel is ON

Record the hour meter reading at replacement

Select the type of filter replacement

Clean the inside of the housing when changing filters

Sign off on the engine air filter check

!WARNING: At operating temperature, hydraulic oil is hot. DO NOT permit oil to contact the skin and cause a burn.

!CAUTION: DO NOT permit dirt to enter the hydraulic system when the hydraulic oil level is checked or the filter is changed. Never operate the hydraulic pumps without hydraulic oil in the hydraulic system. The operation of the hydraulic pumps without hydraulic oil will cause damage to the pumps.

Only use the hydraulic oil specified in Approved Oils, Fluids, and Grease. Additives in the hydraulic system oil may damage the hydraulic system. Before using additives, contact your local Hyster dealer.

Check hydraulic oil level at the level indicator when the carriage is lowered and the engine stopped.

If hydraulic oil level is in the red area, record added volume.

Sign off on the hydraulic system oil check

WARNING: Lower the lift mechanism completely. Never allow anyone under a raised carriage. DO NOT put any part of your body in or through the lift mechanism unless all parts of the mast are completely lowered and the engine is STOPPED.

Before making any repairs, use chains to secure the mast weldments and carriage into position so that they cannot move. Make sure the moving parts are attached to a part that does not move.

DO NOT repair a worn lift chain. Replace both lift chains when one or both lift chains are worn.

WARNING: Adjustment or repair of the lift chains must be done by authorized personnel.

Check that the oil film on the outside of the lift chains is intact and that the oil at the links is still free flowing.

Make sure both chains are slack during parking.

If oil is not sufficiently present, or if lift chains produce noises under operation, there is an increased risk for chain failure.

When the oil film is still intact, check absence of following conditions: Broken, damaged or missing chain link plates.

Damaged, turned or protruding link pins.

!CAUTION: Disposal of lubricants and fluids must meet local environmental regulations.

Drain water from the fuel/water separator when the warning light on the instrument panel is ON during operation. The fuel/water separator is located at the left-hand side of the truck. See Figure 38.

Open the drain valve by turning the valve counter clockwise until draining occurs.

Drain water into a cup until clean fuel flows from the valve.

Upload a photo of the drained water

Sign off on the daily water separator and final fuel filter check

Window wipers operate correctly

Select components to be replaced

Sign off on the daily windows and mirrors inspection