Hyd‑Mech Group Pivot Band Saw M20A

Warning: This lubrication procedure requires trained personnel with PPE!

Is the M-16, M-20 band saw operational?

If band saw is not operational, report the issues to the maintenance team and stop the procedure

Sign off on the band saw lubrication

Warning: This procedure requires trained personnel with PPE!

Enter the machine's hour meter reading

Is the machine's hour meter reading above 500?

If the machine's hour meter reading is not above 500, stop the procedure

Choose the replacement filter used

Was the filter replacement successful?

Sign off on the filter replacement

Oil visual inspection should be conducted with every filter change for the following signs of degradation:

If one of the above is observed, oil should be changed.

Enter the machine's hour meter reading

Enter the date of the last oil change

Did the oil pass the visual inspection?

Sign off on the hydraulic oil change

Warning: This procedure requires trained personnel with PPE!

The blade brush assembly is found behind the drive side door.

Is the blade brush assembly in place?

To adjust the assembly, loosen the hex nut with a 9/16” wrench.

Turn the set screw counter clockwise with a 3/16” Allen key.

Is the set screw turned counter clockwise?

Adjust the set screw so that the brush cleans to the bottom of the blade gullets and tighten the hex nut.

Is the set screw adjusted and the hex nut tightened?

Warning: This procedure requires trained personnel with PPE!

Head lowered to the bottom of its stroke?

Guide arm moved to its fully open position?

Upload a photo of the feed rate cover and cable before removal

Feed rate cover and cable removed?

Blade not touching the out-feed table?