Hoshizaki Counter Showcase HNC-210BA-L-R

Unplug the showcase before cleaning

Ensure the showcase is not disassembled beyond the illustrated figure

Confirm no contact or wetting of machine compartment parts

Clean the interior and food mounts daily for sanitary use

Use a soft cloth soaked in warm water to clean the exterior

Ensure no water jet is used for cleaning the exterior

Use only a neutral cleaner for cleaning

Pre-maintenance Safety Instructions

Unplug the showcase before starting any cleaning or maintenance operations

Ensure not to disassemble the showcase further than illustrated in Fig. 1

Avoid touching or wetting the machine compartment parts

Push the test button to simulate a ground fault on the load circuit

Did the interrupter trip successfully?

Ensure the showcase is not disassembled further than illustrated in Fig. 1

Confirm no contact with machine compartment parts

Hold the tabs at the bottom of the louver and lift them up

Pick the frame of the air filter and pull it out toward you

Pre-maintenance Safety Instructions

Unplug the showcase before starting any cleaning or maintenance operations.

Ensure the showcase is not disassembled further than illustrated in Fig. 1.

Confirm that no machine compartment parts are touched or wet.

Condenser Inspection and Cleaning

Check the condenser for dirt or debris accumulation.

Clean the condenser using a brush or vacuum cleaner if required.

Note any additional cleaning frequency required based on the showcase location.

Visually inspect the exterior of the shipping container for severe damage

Report any severe damage to the carrier

Ensure no packing material is left in the showcase

Remove shipping tape holding the door