Honeywell Fixed Gas Detector SPLLH1XAXCXNZZ

Connect your smartphone with the target gas detector via Bluetooth.

Place the detector in inhibit mode using the mobile app.

Connect a cylinder of reference gas to the target detector using a suitable tube.

Apply the bump test gas to the detector.

Specific Instructions for CO Versions

Apply 100 ppm of carbon monoxide at a flow rate of 300 ml/min for 3 minutes.

On versions that feature the Bluetooth® link, it is preferential to use a smartphone running the app to perform maintenance tasks.

This section describes how to perform a calibration using the control buttons and the internal maintenance status indicator. Before starting calibration, make sure that the gas detector is powered on.

Press and hold the UP button for 2 seconds to activate inhibit mode.

Connect the positive probe of a voltmeter to the positive terminal.

Connect the negative probe to the negative terminal of the output voltage monitor.

WARNING: Use only genuine replacement sensors

CAUTION: Power down or use maintenance mode before replacing sensor

Is the Sensepoint XCL powered down or in maintenance mode?

Connect smartphone to Sensepoint XCL via Bluetooth and select Change Sensor

Press and hold the UP button for 10 seconds to enter sensor replacement mode

Pull out the gas sensor to remove it

Insert a new sensor ensuring correct alignment of sensor pins