Honda Mower HRN216VKA

Change engine oil every 25 hours when used under heavy load or in high outside air temperatures.

Change the oil after the first month or 5 hours of use.

Change the oil every 6 months or 50 hours of use.

Change the oil more frequently when used under heavy load or high outdoor temperatures.

Drain the used oil while the engine is warm.

Wipe the oil filler area clean, and then remove the oil filler cap/dipstick.

Place a suitable container next to the mower to catch the used oil, and then tilt the mower on its right side.

Engine oil changed every 25 hours when used under heavy load or in high outside air temperatures?

Engine oil changed after the first month or 5 hours of use?

Engine oil changed every 6 months or 50 hours of use?

Engine oil changed more frequently when used under heavy load or high outdoor temperatures?

Used oil drained while the engine is warm?

Oil filler area cleaned before removing the oil filler cap/dipstick?

Mower tilted on its right side to drain the used oil?

Engine used under heavy load or in high outside air temperatures?

If yes, change engine oil every 25 hours.

Drain the used oil while the engine is warm.

Place a piece of cardboard or drop cloth on the ground.

Warning: Ensure the engine is not running when adjusting the cutting height.

Are both front and rear adjustment levers in the same position?

Select the desired grass height

Adjust the rear cutting height adjustment lever first.

Did you lift the mower up slightly before adjusting the lever?

Did you pull the adjustment lever toward the wheel and move it into the desired height?

Adjust the front cutting height adjustment lever to match the rear height setting.

Is the front cutting height adjustment lever matching the rear height setting?

If unsure about the cutting height, start with a high setting.

Warning: Handle with care to avoid damaging the blade control cable

Handlebar adjust knobs in the unlocked position

Blade control lever against the handlebar

Handlebar raised into the mowing position without damaging the blade control cable

Select the hole for adjust knobs

Handlebar adjust knobs turned 90 degrees into the lock position

Both sides of the handlebar are at the same height

All cardboard removed from around the handlebar

Sign off on the handlebar adjustment