Hobart Hobart - Champion 10,000 Champion 10,000

After tuning engine, check engine speeds with a tachometer (see table). If necessary, adjust speeds as follows:

Start engine and run until warm

Remove wrapper to access speed adjustments

Move Engine Control switch to Run/Idle position

Loosen mounting screws. Adjust solenoid position so engine runs at idle speed. If necessary, back out idle speed screw so solenoid can be moved to correct position

Blow out or vacuum inside. During heavy service, clean monthly.

Change engine oil and filter according to engine owner's manual

Close valve and valve cap before adding oil and running engine

Fill crankcase with new oil to full mark on dipstick (see Section 8-1);l 4 Fuel Filter

Replace line if cracked or worn

Change engine oil and filter according to engine owner's manual

Close valve and valve cap before adding oil and running engine

Fill crankcase with new oil to full mark on dipstick (see Section 8-1);l 4 Fuel Filter

Replace line if cracked or worn

Do not run engine without air cleaner or with dirty element

Wash wrapper with soap and water solution. Allow wrapper to air dry completely

Spread 1 tablespoon SAE 30 oil evenly into wrapper. Squeeze out excess oil

Replace element if dirty, oily, or damaged;