Hobart Hobart - Handler 125 Handler 125

Disconnect power before maintaining.

- Repair or replace cracked weld cable

- Clean and tighten weld terminals.;

Blow out or vacuum inside. During heavy service, clean monthly.;

Pivot pressure adjustment knob down, and lift pressure assembly up.

Remove screws and pivot tube plate. Lift out pressure arm pivot tube, and slide inlet wire guide out of tube. Slide replacement wire guide into tube, and place tube back into drive assembly. Be sure tip of wire guide is as close to drive roll as possible without touching. Reinstall plate and tighten screws.

1. Remove nozzle. Cut off wire at contact tip, and remove contact tip and tip adapter.

2. Open pressure assembly. Retract wire from liner onto spool.

3. Hold wire tightly to keep it from unraveling. Secure end of wire at spool.

4. Remove screws (3) from cover, and remove cover from wire drive assembly.

5. Lay gun cable out straight, and blow out liner.

Reassemble drive cover and gun in reverse order from taking it apart.;

Drive motor protection circuit protects drive motor from overload. If drive motor becomes inoperative, release gun trigger and wait until protection circuit resets allowing drive motor to feed wire again.;