Hatco Food Cabinet FSD-1X

Ensure the correct model is being serviced

Pull down the spring-mounted coupling to compress

Tip the rack until the rack shaft clears the motor shaft

Ensure the bow cotter pin is not removed from the rack shaft

Insert the rack into the cabinet and place the rack bottom point in the dimple located at the center of the cabinet floor

Pull down the spring-mounted coupling to compress

Setting the De-Liming Detection Mode

Press and hold either the key or key for four seconds

Select the de-liming detection mode

Did the CABINET TEMPERATURE display show the correct status for three seconds?

Is the de-liming detection mode set correctly?

Describe any issues encountered during the procedure

Turn OFF power switch, unplug power cord, and allow unit to cool

Ensure the unit is not submerged or saturated with water

Verify that only Genuine Hatco Replacement Parts are used for service

Turn off the unit, unplug the power cord, and allow the unit to cool

Wipe down all interior and exterior metal surfaces with a damp cloth

Remove stubborn stains with a non-abrasive cleaner

Turn off the unit and unplug the power cord

Perform the Draining the Water Reservoir procedure

Fill the water reservoir with a mixture of 75% water and 25% white vinegar

Ensure no flavored vinegar is used

Pull the LED light strip from the clips securing it to the corner

Pull the top of the LED strip down and out of the LED housing to expose the wire connectors

Disconnect the wire connectors from the LED light strip being replaced

Installation of New LED Light Strip