Genie Personnel Lift CWP-15S DC

Inspect all base wiring for burnt, chafed, corroded and loose wires

Inspect inside of the ground control box for burnt, chafed, corroded and loose wires

Inspect inside of the base junction box for burnt, chafed, corroded and loose wires

Inspect hydraulic power unit for burnt, chafed, corroded and loose wires

Inspect all external machine electrical cables for burnt, chafed, corroded and loose wires

Inspect inside of the platform control box for burnt, chafed, corroded and loose wires

Inspect DC models: battery pack for burnt, chafed, corroded and loose wires

Inspect AC power supply cord for burnt, chafed, corroded and loose wires

Extremely dirty conditions may require that the casters and wheels be inspected more often.

1 Visually inspect each wheel for cuts, cracks or unusual wear.

2 Move the machine on a flat smooth surface and check that the wheels roll smoothly.

- Inspect the Mast Assembly for Wear

Detection of excessive or unusual wear in the mast assembly is essential for safe machine operation.

An unsafe working condition exists if the mast assembly has excessive wear and/or does not operate smoothly, free of hesitation and binding.

2 Raise the platform until 3 to 5 inches (7.6 to 12.7 cm) of each column is visible.

Operator's and Responsibility Manuals present and in good condition

Storage container and lid present and in good condition

All decals and placards in place and legible

No visible damage or missing parts

Base operation tested and working properly

Auxiliary Platform Lowering Operation tested and working properly

Manual Platform Lowering Operation tested and working properly

Battery and Battery Charger in good condition