Genie Personnel Lift CWP-15S AC

Extremely dirty conditions may require that the casters and wheels be inspected more often.

1 Visually inspect each wheel for cuts, cracks or unusual wear.

2 Move the machine on a flat smooth surface and check that the wheels roll smoothly.

- Inspect the Mast Assembly for Wear

Detection of excessive or unusual wear in the mast assembly is essential for safe machine operation.

An unsafe working condition exists if the mast assembly has excessive wear and/or does not operate smoothly, free of hesitation and binding.

2 Raise the platform until 3 to 5 inches (7.6 to 12.7 cm) of each column is visible.

- Inspect the Operator's and Responsibility Manuals

Maintaining the operator's and responsibility manuals in good condition is essential to safe machine operation.; Manuals are included with each machine and should be stored in the container provided at the platform.; An illegible or missing manual will not provide safety and operational information necessary for a safe operating condition.

1 Check to be sure the storage container and lid are present and in good condition.

2 Check to make sure that the operator's and responsibility manuals are present and complete in the storage container at the platform.

3 Examine the pages of each manual to be sure that they are legible and in good condition.

4 Always return the manuals to the storage container after use.

Contact your authorized Genie distributor or Genie Industries if replacement manuals are needed.

- Inspect the Decals and Placards

- Inspect the Electrical Wiring

Maintaining electrical wiring in good condition is essential to safe operation and good machine performance.; Failure to find and replace burnt, chafed, corroded or pinched wires could result in unsafe operating conditions and may cause component damage.

WARNING; Electrocution hazard. Contact with hot or live circuits may cause death or serious injury. Remove all rings, watches and other jewelry.

1 Inspect the following areas for burnt, chafed, corroded and loose wires:

• inside of the ground control box

• inside of the base junction box

• all external machine electrical cables