GE Medical Systems Information Technologies Monitor PRO 400 BP

Ensure the battery is fully charged before storage.

Connect the Monitor to an AC power source to charge the battery.

Is the Monitor switched off during charging?

Record the charging time if the Monitor is switched on.

Record the charging time if the Monitor is switched off.

Does the battery hold a charge?

Replace the battery if it no longer holds a charge.

Monitor and Accessories Cleaning

Wipe the exterior of the Monitor with a soft cloth dampened with mild detergent.

Inspect the Monitor and accessories for wear and damage.

Ensure the unit is not immersed in water or cleaned with isopropyl alcohol or other solvents.

Ensure the following materials are available

Apply cuff hose plugs before cleaning.

Prepare enzymatic detergent and 10% bleach solution in separate spray bottles.

Spray detergent liberally on the cuff and allow to sit for 1 minute if material is dried on.

Has the BP parameter calibration been checked?

Record any doubts about the validity of the readings

Has a leak test of the BP parameter been performed?

Record any doubts about the validity of the pressure readings

Refer calibration and leak testing to qualified service personnel

Access the DINAMAP PRO Monitor Service Manual from Critikon for full calibration details