Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

FRISTAM Shear Pump FSPE 3532/134/175A

Create an account to install this asset package.

Maintenance Plans for FRISTAM Shear Pump Model FSPE 3532/134/175A

Integrate maintenance plans directly into your work orders in MaintainX.

5000 Hourly KF Models Shaft Bearing Lubrication

Warning: This procedure requires trained personnel with PPE!

Bearing cap removed

Pump shaft forced out toward the motor side

Bearing nut and guard plate removed

Outer race of the cylindrical roller bearing removed

Note: All parts that are gray in the above figure remain on the shaft

Surfaces of all parts cleaned and checked for damage

Any parts replaced?

Cylindrical roller bearing relubricated

Run this procedure

5000 Hourly L1 Model Shaft Bearing Lubrication

Warning: This procedure requires trained personnel with PPE!

Cover off of the bearing block

Bearing cap removed on the pump side

Bearing cap removed on the motor side

Shaft forced out in the direction of the pump head

Note: All parts that are gray in the above two figures remain on the shaft

Surfaces of all parts cleaned and checked for damage

Select the lubricant used

Pump shaft with the bearing pressed into the bearing block

Run this procedure

5000 Hourly L2, L3, L4 Models Oil Change

Motor reached normal operating temperature

Motor turned off and secured from accidental turn on

Oil collection container placed under the oil drain plug

Caution! Danger of burning from hot oil. Wear suitable protective gloves.

Oil drain plug loosened and removed

Oil completely drained and disposed of in accordance with local regulations

Oil drain plug and seal cleaned and remounted

Type of oil used

Amount of oil used (refer to Table 4 'Oil volumes')

Run this procedure

Model L Coupling Replacement

Warning: Only use couplings approved by Fristam. The coupling must be appropriate for the characteristic curve of the pump. If you have any questions, please contact Fristam.

Motor turned off and secured from accidental activation

Coupling guard removed

Pump and motor detached from base frame or foundation

Coupling turned off in accordance with motor manufacturer's specifications

Old coupling parts disposed in an environmentally friendly manner

New coupling parts placed on the drive shaft and gear shaft

Motor placed on base frame or foundation and fastening screws slightly tightened

Parallel and angular misalignment of shafts checked

Run this procedure

Motor Replacement

Turn off the motor and prevent it from being able to be turned on accidentally

Remove the pump head