Esco Micro Laminar Flow Clean Bench AHC-4D2

Clean the exterior surfaces of the cabinet using a damp cloth

Check all service fixtures for proper operation

Describe any issues found with the service fixtures

Ensure the clean bench is powered down

Disconnect the clean bench from the electrical supply

Remove the power clips at the ends of the bulbs

Remove the bulbs from the mounting clips

Replace the power clips on the ends of the new bulbs

Wipe the work surface, side walls, and inner back walls with appropriate disinfectant

Did you follow up with a 70% ethanol rinse?

Ensure no chlorine-based disinfectants were used

Ensure only hands entered the clean bench during cleaning

Ensure power cord is detached from the main power supply inlet

Replace the disposable pre-filter

Inspect the cabinet for physical abnormalities or malfunction

Stainless Steel Surface Cleaning

Clean stainless steel surfaces with MEK to remove stubborn stains or spots

Wash the steel surface immediately with clean water and liquid detergent

AHC (D-SERIES) Filter Replacement Instructions

Remove the back cover held by phillip pan head screws

Remove the nuts on the 2 sides (top and bottom) of the vertical clamping

Remove all vertical clampings and u-plates

Carefully remove the supply filter

Replace new filter by reversing the above steps

AVC (D-SERIES) Filter Replacement Instructions

Remove the perspex cover held by screws M4 in front and thumb screws at the back

Remove the sensor box held by screws M4