Doosan Portable Light Tower L6-60HZ-T4F

Bolts and nuts on the engine - Retighten

If water sedimenter is installed, drain water every 500 service hours or 1 year

Sign off on the air cleaner service

The Air Cleaner Assembly (housing) should be inspected every three months or 500 hours for any leakage paths.

NOTE: Ensure the inlet is free from obstruction.

Ensure the air cleaner mounting bolts and clamps are tight and the air cleaner is mounted securely. Check the air cleaner housing for dents or damage to the cleaner which could lead to a leak.

2. Fuel/Water Separator Element Check

Each week the tower lifting cables should be inspected to ensure the ends are attached securely. The cables should be checked for fraying or other damage and replaced if damaged. Also, the pulleys should be checked for unusual wear or damage and replaced if worn excessively or damaged.

All tower locking pins should be checked weekly. Replace any missing or damaged pins before lifting the unit or raising the tower.

1. Air cleaner element - Clean, Check, Replace

Proper maintenance of the air cleaner provides maximum protection against airborne dust.

Squeeze the rubber valve (Precleaner Dirt Dump) periodically to ensure that it is not clogged.

To service the air cleaners, proceed as follows:

1.2. Inspect Air Cleaner housing for any condition that might cause a leak. Correct as necessary.

1.3. Wipe inside of Air Cleaner housing with a clean, damp cloth to remove any dirt accumulation to allow a better seal for Filter element gasket.