Donaldson Torit Shaker Dust Collector VS-2400

1. Monitor the physical condition of the valve and auger and repair or replace any damaged components.

Routine inspections will minimize downtime and maintain optimum system performance. This is particularly important on continuous-duty applications.

2. Monitor pressure drop across filters.

Abnormal changes in pressure drop may indicate a change in operating conditions and possibly a fault to be corrected.

Loosen four filter support knobs

Turn the retaining ring counterclockwise to release the ring and filter

Remove the retaining ring and filter and dispose of filter properly

WARNING: Use proper safety and protective equipment when removing contaminants and filters. Dirty filters may be heavier than they appear. Use care when removing filters to avoid personal injury and/or property damage. Turn power off and lock out all power before performing service or maintenance work. Do not operate with missing or damaged filters.

Power turned off and locked out?

Safety and protective equipment used?

Prefilter reinstalled with top edge against the upper end cap of the filter cartridge?

Screen stretched for a tight fit and secured using a hook-and- loop fastener?

Prefilter covering all holes in the perforated liner?

Sign off on the prefilter removal

NOTICE: To avoid possible damage to the fan motor maintain a seal below the collector if servicing the dust storage device while the fan is running.

Empty dust container(s) (drum or bin) as necessary to minimize dust in the hopper.

If the optional 5-gallon pail pack or 55-gallon drum attachment is used, empty when dust container is 2/3 full.

WARNING: Sharp edge of slide gate may result in personal injury while closing the slide gate. Keep hands clear when operating the slide gate.

If optional slide gate is used, close gate before servicing dust container.

Check integrity of gasket under drum cover.

Replace or reinstall dust container and open gate (if applicable).

Sign off on the dust disposal procedure