Donaldson Torit Mist Collector DMC-MMB

Remove the junction box cover plate

Attach the ground wire to the ground terminal

Attach the three hot wires to the remaining terminals

Replace junction box cover plate

Sign off on the junction box maintenance

Warning: Replace the second-stage filter wrap and third-stage filter cartridge at the same time for easy maintenance.

Upload a photo of the removed filter cartridge

New filter and wrap placed on the filter retention platform, gasket side up

Filter slid back as far as it will go and centered side-to-side

Filter retention lever lifted up and access door closed

Sign off on the filter cartridge replacement

Remove the container by unscrewing the container from the cap

Note: Close the faucet before turning the collector back ON

The optional drain collection container is available for use with an impact separator ONLY. A semi-clear one-gallon plastic container attached to the bottom of the impact separator collects small particles and coolant

Install the container onto the bottom of the impact separator

The container’s faucet must be closed when the unit is in operation

Warning: Electrical work during installation must be performed by a qualified electrician and comply with all applicable national and local codes.

Turn power off and lock out electrical power sources before performing service or maintenance work.

Check that the collector is clear and free of all debris before starting.

Do not install in classified hazardous atmospheres without an enclosure rated for the application.

Optional fans over 600 lbs must be independently supported.

Check all electrical connections for tightness and contact.

Motor and fan should be wired for clockwise rotation when viewed from the back of the motor.

Warning: Do not interchange a power lead with the ground wire. Severe damage or personal injury may result.

All access panels should be sealed and secure.

⚠️ WARNING: Use proper safety and protective equipment when removing contaminants and filters. Dirty filters may be heavier than they appear. Use care when removing filters to avoid personal injury.

Note: Replace the second-stage filter wrap and third-stage filter cartridge at the same time for easy maintenance.

Remove the filter cartridge by pulling the filter retention lever out and down to a horizontal position. Remove cartridge from unit.

Pull wrap from filter cartridge and dispose of properly.

Install new wrap, aligning the top of the wrap to the top of the cartridge and fasten securely with hook and loop fastener.

Replace filter cartridge and secure with filter retention mechanism.

⚠️ NOTICE: Do not operate the collector without the second-stage filter wrap installed. Significant reduction in filter cartridge life may result.

Sign off on the filter wrap replacement