Donaldson Torit Dust Collector UMA 250 Bin Base

CAUTION: Electrical work during installation, service or maintenance must be performed by a qualified electrician and comply with all applicable national and local codes.

Turn power off and lock out all power before performing service or maintenance work.

Check that the collector is clear and free of all debris before starting.

Do not install in classified hazardous atmospheres without an enclosure rated for the application.

Check all electrical connections for tightness and contact.

Check for proper rotation on all motors.

CAUTION: Do not look into fan outlet to determine rotation. View the fan rotation through the back of the motor.

Check that the exhaust plenum is free of tools or debris before checking blower/fan rotation.

Stand clear of exhaust to avoid personal injury.

- Use proper equipment and adopt all safety precautions needed for servicing equipment.

- Use appropriate access equipment and procedures. Note the standard collector is not equipped with access platforms unless noted on the specification drawings.

- Electrical service or maintenance work must be performed by a qualified electrician and comply with all applicable national and local codes.

- Turn power off and lock out all power before performing service or maintenance work.

- Do not install in classified hazardous atmospheres without an enclosure rated for the application.

1. Monitor the physical condition of the collector and repair or replace any damaged components. Routine inspections will minimize downtime and maintain optimum system performance. This is particularly important on continuous-duty applications.

2. Monitor pressure drop across filters. Abnormal changes in pressure drop may indicate a change in operating conditions and possibly a fault to be corrected.

- Use proper safety and protective equipment when removing contaminants and filters.

- Dirty filters may be heavier than they appear.

- Use care when removing filters to avoid personal injury and/or property damage.

- Turn power off and lock out all power before performing service or maintenance work.

- Do not operate with missing or damaged filters.

1. Turn power to collector OFF. Open or remove the filter access door.

2. Lower the retention handles in the bag chamber (for UMA 40 model size, loosen wing nuts on top of clean air plenum until filter frame releases from seal gasket).