Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant
Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.
Find all the essential guides in one place.
Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more
Pre-built workflows to keep your asset running smoothly.
Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more
Integrate maintenance plans directly into your work orders.
Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more
Access the parts list for your equipment in MaintainX.
Drive Motor
B2 Rollers
Tensioning System
+ 40 more

The Delfield Company Refrigeration Equipment 6025XL-SH
Create an account to install this asset package.
Integrate maintenance plans directly into your work orders in MaintainX.
Gasket Maintenance
Basic Maintenance — Gasket Maintenance
Clean the gasket with warm soapy water
Avoided using full strength cleaning products?
Avoided using sharp tools or knives?
Inspect gasket for mold and mildew
Inspect gasket for brittleness
Inspect gasket for tears or damage
Replace gasket if necessary
Defrost Timer Calibration
Defrost Timer Programming Guide (All Models)
Set Defrost Time dip switch
Set Cycle Time dip switch
Adjust defrost time for two and three door models
Adjust defrost time for one door models
Adjust cycle time for one door models
Adjust defrost initiation for two and three door models
Check back-up time setting
Safety Precaution
1 Monthly Condenser Coil Cleaning
Cleaning the Condenser Coil
Inspect the condenser coil for debris and dust accumulation
Is a simple brush sufficient for cleaning?
Is a vacuum or compressed air needed for cleaning?
Is a de-greasing agent required for cleaning?
Spray the condenser coil with de-greasing agent if necessary
Blow through the condenser coil with compressed air if necessary
Ensure no high pressure water is used during cleaning
Is the condenser coil totally blocked?
Refrigerator Cleaning
Maintenance
Turn the thermostat to OFF and disconnect the unit from the power source
Clean the interior and exterior using appropriate cleaning solutions
Rub with the grain of the stainless steel when cleaning the exterior
Avoid using abrasive cleaners
Stainless Steel Care and Cleaning
Use appropriate cleaning tools for stainless steel
Avoid using steel pads, wire brushes, or scrapers
Use alkaline based or non-chloride cleaners
Time Clock Calibration
Operation — To Set Time of Day (Two & Three Door Models Only)
Grasp the knob of the Paragon 8145 time clock dial in the center of the inner (2 hour) dial and rotate it in a counter-clockwise direction.
Continue turning until the correct time of day on the outer dial lines up with the time pointer.
Was the correct time set on the outer dial?
Ensure operation is performed during initial start-up or after power interruption.
Safety Precautions
Disconnect power supply before servicing.
Is the power supply disconnected?
Access the parts list for your equipment in MaintainX.
Door Gasket
1701280
Evap Fan Motor
2162691
Evap Fan Blade
3516172
Cond. Fan Motor
2162688
Cord & Plug
2183541
Door Gasket
1701280
Evap Fan Motor
2162691
Evap Fan Blade
3516172
Cond. Fan Motor
2162688
Cord & Plug
2183541
Door Gasket
1701280
Evap Fan Motor
2162691
Evap Fan Blade
3516172
Cond. Fan Motor
2162688
Cord & Plug
2183541
MaintainX Assist is your expert colleague, on call 24/7, helping your team find the answers they need to keep equipment running.
Reduce Unplanned Downtime
Ensure your team follows consistent procedures to minimize equipment failures and costly delays.
Maximize Asset Availability
Keep your assets running longer and more reliably, with standardized maintenance workflows from OEM manuals.
Lower Maintenance Costs
Turn any technician into an expert to streamline operations, maintain more assets, and reduce overall costs.
Thousands of companies manage their assets with MaintainX













