Crown Very Narrow-Aisle Reach Trucks 30TSP

CHECK YOUR TRUCK BEFORE STARTING WORK

Harness, tether, snap hooks and mounting points are in good condition

Safety shields are clean and clear

Battery water level is OK and vent caps are in place

Battery retainer and side cover are properly installed

All wheels are in good condition

Both forks are secure and not bent, cracked or badly worn

WHEN YOU INSTALL OR CHANGE BATTERIES:

- Turn the truck OFF. Make sure the parking brake is applied and all other controls are in neutral. Disconnect the batteries

- Make certain you use the correct size and weight batteries

Never operate a truck that has underweight or undersized batteries installed

- Use a roller stand to install or remove batteries. Make sure the roller stand is the same height as the rollers in the truck's battery compartment. Also be certain the roller stand is at least as long as your batteries

- Never let anything metal touch the top of the cells. You could cause sparks or do damage to the batteries. Use an insulator (such as plywood) when necessary

- Use an approved spreader bar to place the batteries on, or remove them from a stand. Make sure you adjust the spreader bar hooks to fit the batteries

Test drive in an uncongested area

All hydraulic functions working properly

Truck can drive slowly in both directions

Truck can drive through the full speed range in both forward and reverse

Braking and plugging distances in forward and reverse are safe

Wire guidance operation is functional

Report any issues to your supervisor

Sign off on the daily truck test