CAT Plunger pump 3560

Warning: Each system's maintenance cycle will be exclusive. If system performance decreases, check immediately.

If no wear at 1500 hours, check again at 2000 hours and each 500 hours until wear is observed.

Note: Valves typically require changing every other seal change.

Duty cycle, temperature, quality of pumped liquid and inlet feed conditions all effect the life of pump wear parts and service cycle.

All system accessories and connections checked?

Sign off on the plunger pump check

Clean Filters. Use adequate mesh size for liquid and pump specifications.

Each system's maintenance cycle will be exclusive. If system performance decreases, check immediately. If no wear at 1500 hours, check again at 2000 hours and each 500 hours until wear is observed. Valves typically require changing every other seal change. Duty cycle, temperature, quality of pumped liquid and inlet feed conditions all effect the life of pump wear parts and service cycle.

Remember to service the regulator/unloader at each seal servicing and check all system accessories and connections before resuming operation.

Enter the current hours of operation

Sign off on the plunger pump check

Crankcase filled with special CAT PUMP oil per pump specifications (4.2 Qts. - 4.0 L)?

Oil changed after initial 50 hours running period?

Oil changed every 3 months or 500 hour intervals?

Oiler adjustment is vertical to start feed, horizontal to stop feed, dial to adjust _x001e_flow rate?

Pump was designed for forward rotation to allow optimum lubrication of the crosshead area?

Reverse rotation is acceptable if the crankcase oil level is increased slightly above center dot to assure adequate lubrication?

* If other than CAT PUMPS special multi-viscosity ISO68 oil is used, change cycle should be every 300 hours.