Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Care Of Sweden Mattress System CuroCell Cirrus

Create an account to install this asset package.

Maintenance Plans for Care Of Sweden Mattress System Model CuroCell Cirrus

Integrate maintenance plans directly into your work orders in MaintainX.

Blown Fuse Replacement

Upload a photo of the fuse in the holder before removal

Is the fuse blown?

Upload a photo of the new fuse

Is the new fuse properly inserted and fastened?

Any visible damage inside the pump?

Upload a photo of the pump after fuse replacement

Is the pump functioning normally after fuse replacement?

Sign off on the fuse replacement

Run this procedure

Buzzer Replacement

Voltage supplied is correct

Connectors and wire leads are not loose

Loosen 2 screws securing the buzzer

Enter the part number from BOM for the new buzzer

Fasten the 2 screws securing the new buzzer

Connect the wire leads connector to the PCB

Sign off on the buzzer replacement

Run this procedure

Front Panel Replacement

Warning: Ensure the device is powered off before starting the procedure

Disconnect all wire leads from the PCB

Loosen the air tube from the pressure sensor

Remove the 4 screws from the PCB

Enter the part no. listed from the BOM

Replace with a new PCB according to the part no.

Fasten the 4 screws

Connect all wire lead connectors in the correct positions on the PCB

Connect the pressure sensor tube in the correct position on the PCB

Run this procedure

Main PCB Replacement

Warning: Ensure the device is powered off before starting the procedure

Disconnect all wire leads from the PCB

Note of where the wires are connected

Loosen the air tube from the pressure sensor

Remove the 4 screws from the PCB

Enter the part no. listed from the BOM

Replace with a new PCB according to the part no.

Fasten the 4 screws

Connect all wire lead connectors and pressure sensor tube in the correct positions on the PCB

Run this procedure

Matress System Adjustment

Assure the voltage supplied from power cord is correct

Switch on the power. The normal power supply light will be illuminated

Press the comfort left/right selection button, and the power button together for 5 seconds, to enter in the calibration procedure

When in the calibration procedure, the On/Off LED will be lit, while the remaining LED lights should not be lit. The compressor will not function as the timing motor is in the repositioning process

When the timing motor repositioning process is finished, the low pressure LED will start flashing. The compressor will start to work and the calibration can begin

Make sure the pump air let is not obstructed, and that the air output is normal

Press the alarm mute button, the low pressure LED will turn off. The LED lights of Comfort 1 and Comfort 2 will light up and flash, and the compressor will stop working. The first part of the calibration is now finished, and the pump is ready to perform the low pressure calibration

Provide a stable 15 mmHg pressure

Press the Alarm mute button, the LED lights of Comfort 1 and Comfort 2 will turn off. After that, the LED lights of Comfort 9 and Comfort 10 will light up and flash, and the compressor will stop working. The low pressure calibration is finished, and the pump is ready to perform the high pressure calibration

Run this procedure